Suzuki Grand Vitara SQ416/SQ420/420WD

Since 1998 of release

Repair and car operation



Suzuka Grandee Vitara
+ The general information
+ Maintenance service and greasing
+ Heater, ventilation and the conditioner
+ Steering
+ Suspension bracket
+ Wheels and tyres
+ Forward приводной a shaft shaft/bearing. An oil epiploon
+ Kardannye shaft
+ Brake system
+ Engines
+ Fuel system
+ Ignition system
+ Start system
+ Release system
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
- Windows, mirrors, locks and security measures. An immobilizer
   - Windows, mirrors, locks and security measures
      + The general description
      + Diagnostics
      - Maintenance service
         + Cleaner and windscreen washer
         The screen wiper electromotor
         The pump стеклоомывателя
         Control system электростеклоподъемниками
         System of blocking of locks (if the system is not established, allowing to get to salon of the car without a key)
         + System of blocking of doors with радиобрелка (if the system is established, allowing to get to salon of the car without a key)
         System of the electric drive of mirrors
         Heater of lateral mirrors (if it is equipped)
         Heater of a forward seat (if it is equipped)
   + Immobilizer
+ Electric equipment







e8f2b5b1

The screen wiper electromotor

 PERFORMANCE ORDER

  1. As is shown in drawing more low, use the battery 12 In to connect a positive conclusion to plug "And" and a negative conclusion to a black wire (2) (for type "And") or to plug "à" (for type "In").

A — type And
B — type In

  1. If the motor (1) works on low turns (45 – 55 mines-1), this normal state. For work check on high turns, connect a positive conclusion of the battery to plug "In" and a negative conclusion to a black wire (2) (for type "And") or to plug "à" (for type "In"). If the motor works on high turns (67 – 83 mines-1), this normal state.
  2. Check of automatic deenergizing.
    1. Connect a positive conclusion 12 In batteries to plug "And" of the motor of a screen wiper (1) and a negative conclusion to a black wire (2) (for type "And") or to plug "à" (for type "In") and include a screen wiper.
    2. Disconnect plug "And" from the battery and switch off a screen wiper.
    3. Connect among themselves plugs "And" and «D» by means of a connecting wire (3) and connect plug "With" to a positive conclusion of the battery. Pay attention that the screen wiper motor works once and stops in final position.
    4. Repeat procedures a – c some times and check up that the motor always stops in this position.

A — type And

B — type In