Suzuki Grand Vitara SQ416/SQ420/420WD

Since 1998 of release

Repair and car operation

Suzuka Grandee Vitara
+ The general information
+ Maintenance service and greasing
+ Heater, ventilation and the conditioner
+ Steering
+ Suspension bracket
+ Wheels and tyres
+ Forward приводной a shaft shaft/bearing. An oil epiploon
+ Kardannye shaft
+ Brake system
+ Engines
+ Fuel system
+ Ignition system
+ Start system
+ Release system
- Transmissions
   - Mechanical transmission (type 1)
      The system description
      - Service out of a workshop
         Oil for a transmission
         The gear change lever
         The illumination switch
         Back fixture of the engine
         Transmission removal
         Transmission installation
         The case-extension piece (for model with a drive on two wheels and engine G16 and J20)
         Oil epiploon of the case-extension piece (for model with a drive on two wheels and engine G16 and J20)
   + Mechanical transmission (type 2)
   + Automatic transmission (4 A/T)
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. An immobilizer
+ Electric equipment


Transmission installation

For installation execute removal procedure in return sequence, paying attention to the following:

Observe values of the moment the inhalings resulted more low.
  • The inhaling moment:
    • (a): 85 Н•м (8.5 kg th, 61.5 pounds-foots)
    • (b): 50 Н•м (5.0 kg th, 36.5 pounds-foots)


  1. Establish exhaust pipes №1 and №2 as it is described in the Head release System, in Section Components.
  2. Reliably establish each clip for wires, a hose and a cable.
  3. Reliably establish a clip for casings of the lever of switching.
  4. After installation of the working cylinder of coupling check up a free wheeling of a pedal of coupling as Coupling is described in the Head, in Section the Free wheeling of a pedal of coupling.
  5. Fill in in a transmission oil for a transmission as it is described in the given Chapter, in Section Oil for a transmission.
  6. Fill in in transfer oil for a transfer gear wheel as it is described in the Head Transfer, in Section Oil of a distributing box.
  7. Attach the battery and check up work of the engine, coupling and a transmission.
  8. Establish карданный a shaft as it is described in Head Kardannye shaft, in Razdele Kardannyj a shaft.