Suzuka Grandee Vitara
+ The general information
+ Maintenance service and greasing
+ Heater, ventilation and the conditioner
+ Steering
- Suspension bracket
- Forward suspension bracket
The general description
+ Diagnostics
- Service out of a workshop
The stabilizer of cross-section stability/plug
Shock-absorber rack
Cylindrical spring
The terminator of a dynamic course of a suspension bracket / a rubber nest of a spring
Wheel nave (including the wheel bearing)
Sharnir/os rotations
The suspension bracket/plug lever
+ Back suspension bracket
+ Wheels and tyres
+ Forward приводной a shaft shaft/bearing. An oil epiploon
+ Kardannye shaft
+ Brake system
+ Engines
+ Fuel system
+ Ignition system
+ Start system
+ Release system
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. An immobilizer
+ Electric equipment
|
Shock-absorber rack
Removal
|
|
|
|
- Remove a bar of a rack (1) (if is available).
|
- Lift the car that the forward suspension bracket freely hung.
- Remove a wheel.
|
|
- Remove the E-shaped ring (1) protecting a brake hose, and remove a brake hose with скобы racks, as shown.
|
|
|
- If there is a system of antiblocking of brakes (ABS), remove a bolt (1) plugs of a wire of the gauge of speed of a forward wheel.
|
|
|
- Remove bolts скобы racks (1), then a jack (3) bottom lever (2).
|
|
|
- Remove nuts of a support of a rack (1). Hold a rack with a hand that it has not fallen.
|
- Remove a rack.
|
|
- Remove a nut of a rack (1), the top nest (2), a support (3), пыльник (4) and the bottom nest (5) from a rack of the shock-absorber (6).
|
|
|
Installation
|
|
- Establish a rack, carrying out in return sequence steps on its removal 1 – 9. Put bolts in the specified direction.
|
|
1 — a shock-absorber rack
2 — the bottom nest
3 — пыльник
4 — a rack support
5 — the top nest
6 — a rack nut |
- Tighten all fixing elements to the specified values of the moment of an inhaling.
- The inhaling moment:
- Rack nut (a): 90 Н•м (9.0 kg th, 65.0 pounds-foots)
- Nut of a support of a rack (b): 55 Н•м (5.5 kg - of m, 40.0 pounds-foots)
- Bolt скобы (c): 95 Н•м (9.5 kg th, 69.0 pounds-foots)
- Bolt (d): 50 Н•м (5.0 kg th, 36.5 pounds-foots)
|
|
|
|
- Installation of a brake hose.
- At installation of a hose do not overwind it. Establish the E-shaped ring (1), without falling outside the limits a surface скобы (2).
|
|
|
|
|
|
