Suzuki Grand Vitara SQ416/SQ420/420WD

Since 1998 of release

Repair and car operation


Suzuka Grandee Vitara
+ The general information
+ Maintenance service and greasing
+ Heater, ventilation and the conditioner
+ Steering
+ Suspension bracket
+ Wheels and tyres
+ Forward приводной a shaft shaft/bearing. An oil epiploon
+ Kardannye shaft
- Brake system
   - Brakes
      The general description
      + Diagnostics
      The diagnostic table
      - Check and adjustment
         Стравливание air from brakes
         Check of free height of the brake lever
         Adjustment of the light switch of brakes
         Check it is superfluous a pedal course
         Check of a free wheeling of the brake lever
         Check of level of a brake liquid
         Check of a brake hose and highway
         Check of the main cylinder
         Check of a brake disk
         Check brake колодки
         Check of a brake boot
         Check and adjustment of a lay brake
         Washing of hydraulic system of brakes
         Check of pressure of a liquid (if the car is equipped LSPV)
         Check of work of the brake amplifier
      Specifications - an inhaling twisting moment
      Necessary materials for service
      The special tool
   + Brake highway/hose the brake cylinder
   + Forward brakes
   + Lay and back brake
   + Antiblocking brake system (ABS)
+ Engines
+ Fuel system
+ Ignition system
+ Start system
+ Release system
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. An immobilizer
+ Electric equipment






e8f2b5b1

Adjustment of the light switch of brakes

Do not apply any lubricant oil or greasing (including anticorrosive, lubricant, etc.) with specified more low sections.

  • The switch of a stoplight (1) (including its top part (2)).
  • The switch (2) adjoining to скобе of the brake lever (3).

If to use oil or greasing, they can get on contacts of the switch and cause their refusal. Also at check, adjustment or replacement of the brake switch, check up that oil or greasing have not got to the zone of the switch adjoining a brake pedal or the top part of the switch. Erase the oil which has got to this zone or greasing.

At installation of the switch of a lamp of a brake (1) adjustment should be carried out as follows.

 PERFORMANCE ORDER

  1. Pull the brake lever on itself and keeping it in this position, adjust switch position so that a backlash between the end of a carving and скобой the brake lever (designated as "an" or «b» in drawing more low).
  2. Then tighten a lock nut with the specified twisting moment of an inhaling (if it is specified).
    • Backlash between the end of a carving and скобой the brake lever
      • For having a lock nut
        • Type «a»: 1.5 - 2.0 mm (0.06 - 0.08 inches)
      • For not having a lock nut
        • «b»: 0.5 - 1.5 mm (0.02 - 0.06 inches)
      • The inhaling moment
        • Lock nut of the switch of a lamp of a brake (a): 7.5 Н•м (0.75 kg th, 5.5 pounds on foot)
A — for having a lock nut
B — for not having a lock nut