Suzuki Grand Vitara SQ416/SQ420/420WD

Since 1998 of release

Repair and car operation



Suzuka Grandee Vitara
+ The general information
+ Maintenance service and greasing
+ Heater, ventilation and the conditioner
+ Steering
+ Suspension bracket
+ Wheels and tyres
+ Forward приводной a shaft shaft/bearing. An oil epiploon
+ Kardannye shaft
- Brake system
   + Brakes
   + Brake highway/hose the brake cylinder
   + Forward brakes
   + Lay and back brake
   - Antiblocking brake system (ABS)
      + The general description
      - Diagnostics
         Safety measures at diagnostics of problems
         The table of diagnostics of malfunctions ABS
         Checks
         Codes of diagnostics of malfunctions
         The system scheme
         Tables
         Check of codes of diagnostics of malfunctions (КДН)
         Vehicle service
         Check of work of hydraulic block ABS
+ Engines
+ Fuel system
+ Ignition system
+ Start system
+ Release system
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. An immobilizer
+ Electric equipment







e8f2b5b1

Check of work of hydraulic block ABS

Using scanner SUZUKI

 PERFORMANCE ORDER

  1. Check up, whether in a good condition the basic brake systems besides АБС.
  1. Check up that pressure of the battery 11 In or above.
  1. Using alarm lamp АБС, check up, whether it is revealed deviations in work АБС. Address to Section Check of codes of diagnostics of malfunctions (КДН) in the given Chapter.
  2. Lift a vehicle.
  3. Establish transmission in neutral position and release a lay brake.
  4. Manually gradually turn each wheel to check up, whether there is no brake jamming. If a brake заедает, correct.
  1. Connect scanner SUZUKI to a data link socket (DLC) (1) at the switched off ignition switch. The special tool: (A) — scanner SUZUKI.
  1. Include an ignition switch and check up solenoid work in a mode "Other checks" (MISC.tests) scanner SUZUKI.
  1. Check up, that each wheel rotated, only at the dumped pressure of brake effort (approximately 0.5 seconds).
  2. If in the given step malfunction is found out, replace the hydraulic block/assemblage of the module of management.