Suzuka Grandee Vitara
+ The general information
+ Maintenance service and greasing
+ Heater, ventilation and the conditioner
+ Steering
+ Suspension bracket
+ Wheels and tyres
+ Forward приводной a shaft shaft/bearing. An oil epiploon
+ Kardannye shaft
+ Brake system
+ Engines
+ Fuel system
+ Ignition system
- Start system
+ The general description
- Diagnostics
Block repair
Analysis
Assemblage
Survey
Work check
Specifications
Type 0.9 кВ
Necessary materials
The special tool
+ Release system
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. An immobilizer
+ Electric equipment
|
Assemblage
|
|
- It is not authorised to wash out, regulate or assort the shock-absorber (a disk муфты coupling).
- New bearings without greasing have been greased, when were delivered as spare parts. Do not wash out маслорастворителем and do not grease with other lubricant substance.
|
|
|
- Check up components (Survey see) and replace on new if necessary.
- Put greasing (the Starter see).
- Establish an anchor on a collar.
- Establish brushes and springs of brushes on щеткодержатель.
- Establish щеткодержатель on an anchor, squeezing out 4 brushes outside.
|
|
1 — a brush
2 — a brush spring
3 — щеткодержатель |
- Establish a back sleeve and then a cap back скобы.
- Establish back скобу.
- Tighten screws щеткодержателя.
|
|
1 — back скоба
2 — screws щеткодержателя |
- Establish assemblage обгонной муфты on a shaft - a gear wheel, paying attention to a direction of installation of a lock ring of a gear.
|
|
1 — обгонная муфта
2 — a lock ring of a gear
3 — a persistent ring
4 — a shaft-gear wheel |
- Insert shaft assemblage into a forward casing, lever position.
|
|
1 — lever assemblage
2 — the lever |
- Establish a lining so that cuts in it were combined with apertures for through bolts in a forward casing.
- Establish a plate and rubber consolidation in a forward casing.
|
|
1 — a lining
2 — planetary transfer
3 — an aperture for a bolt
4 — rubber consolidation |
- Put greasing on a ball and establish a ball in a shaft aperture.
- Establish a collar, an anchor, щеткодержатель and back скобу in a forward casing, having combined the marks put before removal.
- Tighten through bolts.
|
|
1 — bolts
2 — reducer assemblage |
- Establish assemblage of the electromagnetic switch and a protector (if is). Connect a wire (to the motor) to a switch conclusion.
- After the termination of assemblage inspect work.
|
|
1 — the electromagnetic switch
2 — a protector |
|
|
|
|
