Suzuki Grand Vitara SQ416/SQ420/420WD

Since 1998 of release

Repair and car operation

Suzuka Grandee Vitara
+ The general information
+ Maintenance service and greasing
+ Heater, ventilation and the conditioner
+ Steering
+ Suspension bracket
+ Wheels and tyres
+ Forward приводной a shaft shaft/bearing. An oil epiploon
+ Kardannye shaft
+ Brake system
- Engines
   + Mechanical part of engine G16
   + Mechanical part of engine J20
   - Engine cooling
      + The general description
      + Diagnostics
      - Maintenance service
         Check of level of a cooling liquid
         Service and repair of system of cooling
         Washing and filling of system of cooling
         Regulation and check of a tension of a belt of the cooling fan
      + Vehicle routine maintenance
      Necessary service materials
      Technical characteristics of the rotating moment of an inhaling
+ Fuel system
+ Ignition system
+ Start system
+ Release system
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. An immobilizer
+ Electric equipment


Maintenance service

Check of level of a cooling liquid

In order to avoid a burn:

  • Do not uncover the tank while the cooling liquid "boils",


  • Do not uncover a radiator, while the engine and a radiator still hot.

Burning liquid and steam can be splashed out under pressure if any of covers is removed too quickly.


  1. To check up level, lift a cowl and look through "the transparent" tank of a cooling liquid.
  1. There is necessity to uncover no radiator to check up level of a cooling liquid. When the engine will cool down, check up level of a cooling liquid in the tank (1).
  1. Normal level of a cooling liquid should be between marks "FULL" and "LOW" on the tank. If level of a cooling liquid below a mark "LOW" (3), uncover the tank and add a corresponding cooling liquid in the tank to finish level of a cooling liquid to a mark "FULL" (2).
  2. Then close a cover.
  • If antifreeze of the recommended quality is used, there is no necessity to add additional stabilizers or additives which as declare, improve system. They can harm to correct functioning of system.
  • At installation of a cover of the tank level arrows (4) on the tank and a cover.