Suzuki Grand Vitara SQ416/SQ420/420WD

Since 1998 of release

Repair and car operation

Suzuka Grandee Vitara
- The general information
   + Safety measures
   The basic safety measures
   Safety measures at work with the catalyst
   Safety measures at service of electric chains
   + Procedure of check of electric chains
   Interrupting or weak connection
   Safety measures at installation of means of a mobile communication
   + The identification information
   Warning, warning and information labels
   Places of lifting of the car
   The list of the reductions used in the given management
   + The metric information
   The standard moments of inhalings
+ Maintenance service and greasing
+ Heater, ventilation and the conditioner
+ Steering
+ Suspension bracket
+ Wheels and tyres
+ Forward приводной a shaft shaft/bearing. An oil epiploon
+ Kardannye shaft
+ Brake system
+ Engines
+ Fuel system
+ Ignition system
+ Start system
+ Release system
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. An immobilizer
+ Electric equipment

Цены на проектирование и монтаж пожарной сигнализации www.complex-safety.com.

Safety measures at service of electric chains

At a detachment and joining of sockets, necessarily switch off ignition, otherwise electronic components can be damaged.

Be accurate, do not concern contacts of the equipment using microcomputers (electronic blocks of management, such as ECM, PCM, P/S the controller). Т to. The static electricity of your body can damage these components.

Never connect a tester (the voltmeter, an ohmmeter or another) to the electronic block of management, at the disconnected socket. Attempt make it can to lead to its breakage.

Never connect an ohmmeter to the electronic block of management, with the connected socket. Attempt make it can to lead to damage of the electronic block of management and gauges.

Use only the specified measuring devices (voltmeter/ohmmeter). Otherwise exact measurements can be not reached or it can lead to traumas.

At carrying out of measurements on sockets by means of a tester, insert щуп from outside wires (the back party) коннектора.

1 — a socket
2 — щуп

At connection щупа a multimeter from outside contacts of a socket in case of impossibility of connection from outside wires, be extremely accurate, do not bend пины a socket effort of a reciprocal part of the socket opened for connection. In case of a socket presented in drawing more low, connect щуп, as shown, to avoid disconnection of contacts of a covering socket. Never connect щуп a multimeter in a place, calling пина.

1 — a socket
2 — щуп
3 — a calling place пина

At check of sockets, check up пины on незагнутость, and a covering socket on an open condition. Also check up both parts on short circuit, disconnection, corrosion, a dust etc. Before pressure measurement on contacts check up, that pressure АКБ was not below 11 V.Proverka of pressure on contacts at low charge АКБ leads to erroneous results of diagnostics.