Suzuka Grandee Vitara
+ The general information
+ Maintenance service and greasing
+ Heater, ventilation and the conditioner
+ Steering
- Suspension bracket
+ Forward suspension bracket
- Back suspension bracket
The general description
+ Diagnostics
- Service out of a workshop
The shock-absorber
Cylindrical spring
The bottom draught
The top draught
Lateral draught
The back bridge and the wheel bearing
Internal oil epiploon of the back bridge
The case of the back bridge
+ Wheels and tyres
+ Forward приводной a shaft shaft/bearing. An oil epiploon
+ Kardannye shaft
+ Brake system
+ Engines
+ Fuel system
+ Ignition system
+ Start system
+ Release system
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. An immobilizer
+ Electric equipment
|
Cylindrical spring
Removal
|
|
- Lift the car and remove a back wheel.
|
|
- Floor jack (2) prop up the case of the back bridge (1).
|
|
|
- Disconnect an eye of a cable of a parking brake (1) from a frame of the chassis and the plug (3) from a cross-beam (2).
|
|
|
- Remove the bottom fixing bolt (1) shock-absorbers.
|
|
|
- Remove plugs of the gauge of speed of a wheel (1) from the top draught (2) and the bridge case if there is a system of antiblocking of brakes ABS.
|
|
|
- For the right party – remove the E-shaped ring of fixing of a brake tube from a cross-beam and disconnect a hose сапуна from the bridge case.
|
- Gradually lower the case of the back bridge until then when it will be possible to remove a cylindrical spring.
- Remove a cylindrical spring.
|
|
Installation
|
|
|
|
- Establish a cylindrical spring (3) in a nest of a spring (2) on the case of the bridge (1), and then lift the bridge case.
|
|
|
At installation of a cylindrical spring combine the end of a spring with a step part (4) nests of a spring of the back bridge. |
- Establish the bottom bolt of the shock-absorber. A nut do not tighten.
|
|
1 — the body centre
2 — a body outer side |
- Establish the plug of the gauge of speed of a wheel (if is available) and the E-shaped ring and attach a hose сапуна to the bridge case.
|
|
- Attach an eye of a cable (1) to a frame of the chassis (4) and the plug (3) to a cross-beam (2). Clean a jack from under the bridge case.
|
|
|
- Establish a wheel and tighten nuts of a wheel to the specified value of the moment of an inhaling. The inhaling moment: a wheel nut (a): 100 Н•м (10.0 kg th, 72.5 pounds-foots).
|
- Lower the lift and tighten the bottom nut of the shock-absorber to the specified value of the moment of an inhaling. The inhaling moment: the Bottom nut of the shock-absorber: (b) — 100 Н•м (10.0 kg th, 72.5 pounds-foots).
- For a tightening of the bottom nut the Note in Section the Shock-absorber (Installation) see in the given Chapter.
|
|
1 — the body centre
2 — a body outer side |
|
|
|
|
