Suzuka Grandee Vitara
+ The general information
+ Maintenance service and greasing
+ Heater, ventilation and the conditioner
+ Steering
+ Suspension bracket
+ Wheels and tyres
+ Forward приводной a shaft shaft/bearing. An oil epiploon
+ Kardannye shaft
+ Brake system
+ Engines
- Fuel system
- Current maintenance service of a vehicle
The fuel pump
The fuel filter
Fuel wires
Cover of a jellied fuel mouth
Fuel tank
Technical characteristics of the rotating moment of an inhaling
+ Ignition system
+ Start system
+ Release system
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. An immobilizer
+ Electric equipment
|
Current maintenance service of a vehicle
Preventions
|
|
Always observe following cautions before to start service of fuel system of any type. |
- Disconnect a negative cable from the accumulator.
- DO NOT SMOKE, and hang up the tablet "NOT to SMOKE" near to a workplace.
- Always hold near at hand fire extinguisher SO2.
- Work in well aired premise, far away from open fire (such as a gas heater).
- Carry goggles.
- To dump pressure of steams of evaporation of fuel in a fuel tank, uncover a jellied fuel mouth a mouth, and then establish it back.
- As submitting топливопровод still is under a fuel high pressure even after engine switching-off, direct untwisting or a detachment striking топливопровода can cause emission of a dangerous stream of fuel in an untwisting or detachment place. Before to turn off or disconnect submitting топливопровод do not forget to dump pressure of fuel.
- After a detachment топливопровода the fuel small amount can flow out. To lower risk personal травмирования, cover фитинг which you are going to disconnect, shop rags. Put this rags in the container special for it after the detachment is finished.
- Pay attention to that connections of fuel hoses differ for each type of a pipe. Be convinced that you connect and fix a clip each hose correctly, addressing to the below-mentioned.
- Each time when you perform the work demanding lifting of a vehicle, check up clips of fuel hoses on rust presence.
|
|
By means of a short pipe insert a hose until it will not reach a joint of pipes, as shown.
1 — a hose
2 — a pipe
3 — a clip
"And" — clamp strong on distance 3 – 7 mm (0.12 – 0.27 inches) from the hose end.
«b» — 20 – 30 mm (0.79 – 1.18 inches)
|
|
|
By means of following type of a pipe insert a hose to its peripheral projection, as shown.
1 — a hose
2 — a pipe
3 — a clip
"And" — clamp strong on distance 3 – 7 mm (0.12 – 0.27 inches) from the hose end.
«b» — 20 – 30 mm (0.79 – 1.18 inches)
|
|
|
By means of the bent pipe insert a hose to its bent part or until the pipe will not enter into a hose on 20 – 30 mm (0.79 – 1.18 inches). |
|
|
By means of a direct pipe insert a hose until the pipe will not enter into a hose on 20 – 30 mm (0.79 – 1.18 inches).
1 — a hose
2 — a pipe
3 — a clip
"And" — clamp strong on distance 3 – 7 mm (0.12 – 0.27 inches) from the hose end.
«b» — 20 – 30 mm (0.79 – 1.18 inches)
|
|
|
