Suzuka Grandee Vitara
+ The general information
+ Maintenance service and greasing
+ Heater, ventilation and the conditioner
+ Steering
+ Suspension bracket
+ Wheels and tyres
+ Forward приводной a shaft shaft/bearing. An oil epiploon
+ Kardannye shaft
+ Brake system
- Engines
- Mechanical part of engine G16
+ The general description
- Routine maintenance
Compression check
Check of depression of the engine
Check of pressure of oil
Klapannyj backlash
Filtering element of the air filter
Cover of a head of cylinders
The case throttle заслонок and an inlet collector
Collector of the fulfilled gases
Drive belt газораспределительного the mechanism and the tension device for a belt
Маслосборник and a grid of the oil pump
The oil pump
Коромысло the valve, an axis коромысел and a cam-shaft
Valves and head of the block of cylinders
+ Piston rod, piston rings, rods and cylinders
The special tool
Necessary service materials
Technical characteristics of the rotating moment of an inhaling
+ Mechanical part of engine J20
+ Engine cooling
+ Fuel system
+ Ignition system
+ Start system
+ Release system
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. An immobilizer
+ Electric equipment
|
Check of pressure of oil
|
|
Before to check pressure of oil, check up following moments:
-
Oil level in маслосборнике. If oil level is low, add oil to a mark of level of full refuelling (1) on oil щупе.
- Quality of oil. If oil has lost colour or has worsened, change it. The Engine, the Head Maintenance service and greasing see the table in Section to receive recommendations about use of concrete type of oils.
- Oil leaks. If leak is found out, eliminate it.
|
|
|
1 — level of full refuelling
2 — a mark of low level of refuelling |
|
|
- Take out the relay of pressure of oil (1) of the block of cylinders.
|
|
1 — the relay of pressure of oil
2 — the oil filter |
|
|
- Insert the special tool (oil щуп) into the formed empty aperture. The special tool: () — 09915-77311.
|
- Start the engine and warm up it to normal working temperature.
|
|
Be convinced that the gear change lever costs on "Neutral" (for models А/Т put the gear change lever on a range «Р»), both establish a lay brake and block приводные wheels. |
- After warming up increase speed to 4,000 turns in a minute and measure pressure of oil. Technical characteristics of pressure of oil: 330 – 430 кПа (3.3 – 4.3 kg/sm2, 46.9 – 61.1 пси) at 4000 turns in a minute (о/м).
- Muffle the engine and take out oil щуп.
|
|
- Before to put the relay of pressure of oil into place, do not forget to wrap up its carving a sealing tape (1) and to fasten the relay to the specified rotating moment.
|
|
|
The rotating moment of an inhaling: the relay of pressure of oil () — 14 Н•м (1.4 kg th, 10.5 pound on foot). |
|
|
If the edge of a sealing tape supports a relay carving, cut off it. |
- Start the engine and check up the relay of pressure of oil on a leaking.
|
|
|
|
