Suzuka Grandee Vitara
+ The general information
+ Maintenance service and greasing
+ Heater, ventilation and the conditioner
+ Steering
+ Suspension bracket
+ Wheels and tyres
+ Forward приводной a shaft shaft/bearing. An oil epiploon
+ Kardannye shaft
+ Brake system
+ Engines
+ Fuel system
+ Ignition system
+ Start system
+ Release system
+ Transmissions
+ Coupling
+ Transfer
- Forward and back differentials
- Forward диффренциал
+ The general description
+ Diagnostics
- Service out of a workshop
+ Servicing
- Check
Control system of a full drive
Drive
The air pump
+ Removal and installation
Removal
Installation
+ Back differential
+ Windows, mirrors, locks and security measures. An immobilizer
+ Electric equipment
|
Check
Control system of a full drive
|
|
- Establish the special tool on a hose for air, having connected it between the air pump and differential (actuator). Tighten against the stop an adjusting bolt of the special tool. Close a lateral aperture for check of air by means of a fuel hose as a deaf stopper.
- The special tool:
- (A): 09918-18110
- (B): 09367-04002
|
|
Be cautious not to bend a hose. |
- Include the switch of ignition and switch the lever of a gear change from position 2Н in position 4Н.
- Check up that the motor has earned (its sound) within 1 second is audible and has stopped, when the arrow of the device of the special tool has shown the specified value of pressure.
- Check up, whether there is no air leak. Pressure specifications: 30.0 – 45.0 килоПаскалей (0.30 – 0.45 kg/sm2, 4.25 – 6.40 pounds on sq. inch).
- Check up, that the value of pressure shown on a dial of the special tool, has fallen, as soon as the gear change lever is switched in position 2Н.
- Start the motor, again having switched the gear change lever in position 4Н. Ослабьте an adjusting bolt to lower value of pressure on a device dial. The motor should earn and stop again in approximately 4 seconds.
- Having weakened an adjusting bolt of the special tool, switch the gear change lever in position N or 2Н, and then in position 4L or 4Н. The pump motor should stop approximately in 10 seconds after the motor has started to work.
|
|
1 — the corked hose
2 — an adjusting bolt
3 — a tube (to the air pump)
4 — a hose (to the holder of differential)
5 — the differential case |
|
|
|
|
