Suzuki Grand Vitara SQ416/SQ420/420WD

Since 1998 of release

Repair and car operation



Suzuka Grandee Vitara
+ The general information
+ Maintenance service and greasing
+ Heater, ventilation and the conditioner
+ Steering
+ Suspension bracket
+ Wheels and tyres
+ Forward приводной a shaft shaft/bearing. An oil epiploon
+ Kardannye shaft
+ Brake system
- Engines
   + Mechanical part of engine G16
   - Mechanical part of engine J20
      + The general description
      - Routine maintenance
         Compression check
         Check of depression of the engine
         Check of pressure of oil
         Filtering element of the air filter
         The case throttle заслонок and an inlet collector
         Exhaust system collector
         Cover of a head of the cylinder
         Маслосборник and a grid of the oil pump
         The oil pump
         Cover of a chain of synchronisation
         The second chain of synchronisation and натяжитель chains
         The first chain of synchronisation and натяжитель chains
         Cam-shafts and regulators клапанного a backlash
         Valves and head of the block of the cylinder
         Pistons, piston rings, rods and cylinders
      + Assembly armature of the engine
      The special tool
      Necessary service materials
      Technical characteristics of the rotating moment of an inhaling
   + Engine cooling
+ Fuel system
+ Ignition system
+ Start system
+ Release system
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. An immobilizer
+ Electric equipment







e8f2b5b1

Routine maintenance

Compression check

 PERFORMANCE ORDER

  1. Check up pressure of compression upon all four cylinders as follows.
  2. Warm up the engine.
  3. After a warming up stop the engine.

After an engine warming up put the gear change lever on "Neutral" (for models А/Т put the gear change lever in position «Р»), both establish a lay brake and block приводные wheels.


  1. Disconnect a cable of an accelerator (3) from a clip (4) (only for vehicles with the left wheel).
  1. Disconnect муфты ignition coils.
  2. Remove coils of ignition (1).
  3. Remove all spark plugs (2).
  4. Disconnect wires of a fuel injector from муфты (5).
  1. Establish the special tool (компрессиметр) in a spark plug aperture.
    • The special tool
      • (): 09915-64510-001
      • (): 09915-64510-002
      • (): 09915-64530
      • (D): 09915-67010
  1. Switch off coupling (to reduce initial loading by the engine) for models М/Т, and press a pedal of management of giving of fuel against the stop completely to open throttle заслонку.
  1. Start the engine with completely charged accumulator and read the maximum instrument of pressure on компрессиметре.

To measure pressure of compression, start the engine, at least, on 250 turns in a minute, with the help of completely charged accumulator.

Technical characteristics pressure of compression

 

Pressure of compression

The normal

1400 кПа (14.0 kg/sm2, 199.0 пси)

The limiting

1200 кПа (12.0 kg/sm2, 170.0 пси)

The maximum deviation between two cylinders

100 кПа (1.0 kg/sm2, 14.2 пси)

  1. Execute points 9 - 11 on each cylinder to read four instruments.
  1. After check insert spark plugs (2) and coils of ignition (1).
  1. Connect муфты ignition coils.
  2. Connect a cable of an accelerator (3) to a clip (4) (only for vehicles with the left wheel).