Suzuka Grandee Vitara
+ The general information
+ Maintenance service and greasing
+ Heater, ventilation and the conditioner
+ Steering
+ Suspension bracket
+ Wheels and tyres
+ Forward приводной a shaft shaft/bearing. An oil epiploon
+ Kardannye shaft
+ Brake system
+ Engines
+ Fuel system
+ Ignition system
+ Start system
+ Release system
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. An immobilizer
- Electric equipment
+ Body electric equipment
+ Illumination system
- Electric equipment system
+ The general description
+ Diagnostics
+ The works made on the car
- Major repairs
- The generator
Removal
Installation
Dismantling [Type 60 A]
Dismantling [Type 70 A and 80 A]
Survey [Type 60 A]
Survey [Type 70 A and 80 A]
Replacement of brushes
Assemblage [Type 60 A]
Assemblage [Type 70 A and 80 A]
+ Specifications
The inhaling moments
+ Tools/information for drivers
|
Dismantling [Type 60 A]
|
|
- To facilitate reinstallation, put marks in a forward and back casing before to separate them.
|
|
1 — a forward casing
2 — a back casing
3 — marks for combination |
|
|
- Remove bolts of a casing from the generator.
|
- When the lever is inserted between the core статора and a forward casing, divide the generator into forward and back parts.
|
|
1 — a back casing
2 — the core статора
3 — a forward casing
4 — the lever |
|
|
1 — a back casing
2 — the core статора
3 — a forward casing |
- Release a nut of a pulley by means of a vice and remove a pulley.
|
|
- Using a vice, place a pure fabric between a rotor and a vice not to damage a rotor.
- Necessarily keep a rotor in point A. Do not keep it in a zone In as it insufficiently strong.
|
- Remove a rotor from a forward casing.
|
|
1 — a pulley neck
2 — a rotor
3 — a fabric
4 — a vice |
- Removing the forward bearing, remove screws of the holder of the bearing and the holder.
|
|
1 — a forward casing
2 — the screw of the holder |
- Removing the back bearing, an oil hydraulic press.
|
|
1 — the back bearing
2 — a hydraulic press
3 — the general rod
4 — the general tool |
- Remove three screws and a terminal nut "B" the generator.
|
|
1 — the screw
2 — a terminal nut "B"
3 — plug "B" |
- Disconnect contacts статора and remove статор from a back casing and regulator assemblage.
|
|
1 — contact статора (solder) |
- To remove a brush, uncover the holder the holder of a brush and then disconnect a wire of a brush from the regulator plug, using a soldering iron.
|
|
1 — the holder of a brush
2 — solder
3 — a brush spring |
|
|
|
|
