Suzuki Grand Vitara SQ416/SQ420/420WD

Since 1998 of release

Repair and car operation


Suzuka Grandee Vitara
+ The general information
+ Maintenance service and greasing
+ Heater, ventilation and the conditioner
+ Steering
+ Suspension bracket
+ Wheels and tyres
+ Forward приводной a shaft shaft/bearing. An oil epiploon
+ Kardannye shaft
+ Brake system
+ Engines
+ Fuel system
+ Ignition system
+ Start system
+ Release system
- Transmissions
   - Mechanical transmission (type 1)
      The system description
      Diagnostics
      - Service out of a workshop
         Oil for a transmission
         The gear change lever
         The illumination switch
         Back fixture of the engine
         Transmission removal
         Transmission installation
         The case-extension piece (for model with a drive on two wheels and engine G16 and J20)
         Oil epiploon of the case-extension piece (for model with a drive on two wheels and engine G16 and J20)
   + Mechanical transmission (type 2)
   + Automatic transmission (4 A/T)
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. An immobilizer
+ Electric equipment






e8f2b5b1

Service out of a workshop

Oil for a transmission

Check and replacement

 PERFORMANCE ORDER

  1. Before replacement or oil check be convinced that the engine is switched off, and horizontally lift the car.
  2. At the lifted car check up level and oil leak. If leak is found out, eliminate it.
  3. Merge old oil and pour the specified quantity (approximately to уровневого apertures) the new specified oil.
  • Insistently it is recommended to use oil SAE 75W-90.
  • At lifting of the car for any other, than replacement of oil, service, check leak of oil and a condition of hoses сапуна.
  • If in the merged oil there is a water or a rust, check up a hose сапуна and a transmission and transfer casing.
    • The oil specification:
      • Oil mark: API GL-4
      • Viscosity: SAE 75 W-85, 75 W-90 or 80 W-90
      • Oil capacity: 1.5 litres (3.2/2.6 США/Imp. Pints)
The scheme of viscosity of a society automobile engineers (USA).
  1. Tighten a drain stopper (1) and a level stopper / a bulk aperture (2), as set forth below, preliminary put hermetic on a carving. “A”: hermetic 99000-31110. The inhaling moment (a): 23 Н•м (2.3 kg th, 17.0 pounds-foots).

  • It is impossible to fill in transmission oil through a part of the lever of a gear change.
  • Do not weaken and do not remove a bolt of a shaft of an intermediate gear wheel of a backing (3).