Suzuki Grand Vitara SQ416/SQ420/420WD

Since 1998 of release

Repair and car operation



Suzuka Grandee Vitara
+ The general information
+ Maintenance service and greasing
+ Heater, ventilation and the conditioner
+ Steering
+ Suspension bracket
+ Wheels and tyres
+ Forward приводной a shaft shaft/bearing. An oil epiploon
+ Kardannye shaft
+ Brake system
+ Engines
+ Fuel system
+ Ignition system
+ Start system
+ Release system
- Transmissions
   - Mechanical transmission (type 1)
      The system description
      Diagnostics
      - Service out of a workshop
         Oil for a transmission
         The gear change lever
         The illumination switch
         Back fixture of the engine
         Transmission removal
         Transmission installation
         The case-extension piece (for model with a drive on two wheels and engine G16 and J20)
         Oil epiploon of the case-extension piece (for model with a drive on two wheels and engine G16 and J20)
   + Mechanical transmission (type 2)
   + Automatic transmission (4 A/T)
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. An immobilizer
+ Electric equipment







e8f2b5b1

The illumination switch

Refrain from work, while the central exhaust pipe hot.

Removal and installation

At switch replacement be cautious, that the dust has not got to a transmission through a switch aperture.


 PERFORMANCE ORDER

  1. Lift the car.
  2. Remove сцепку () switch wires.

Type 1 and type 2

1 — сцепка the illumination switch
2 — forward карданный a shaft

Type 3

1 — сцепка the illumination switch
2 — forward карданный a shaft
  1. Replace the switch of illumination (1), connect and fix, as was in a starting position.
    • The inhaling moment:
      • (a): 20 Н•м (2.0 kg th, 14.5 pounds-foots) (Type 1)
      • (a): 45 Н•м (4.5 kg th, 32.5 pounds-foots) (Type 2 and type 3)
  2. After replacement of the switch of illumination check up serviceability of work of the switch, having turned the ignition key in position "INCL." (ON), and transfer having switched in backing position. After check of work of the switch, switch off it.

Type 1

2 — the central exhaust pipe
Type 2.
Type 3.

Check

 PERFORMANCE ORDER

  1. Open a latch and disconnect сцепку the illumination switch.
  1. Work of the switch of illumination (1) can be checked up.
  1. The chain should become isolated on its terminals only when the switching lever is in backing position.
  2. On termination of check attach сцепку and clip wires how they have been connected initially.

At switch replacement be cautious, that the dust has not got to a transmission through a switch aperture.