Suzuki Grand Vitara SQ416/SQ420/420WD

Since 1998 of release

Repair and car operation



Suzuka Grandee Vitara
+ The general information
+ Maintenance service and greasing
+ Heater, ventilation and the conditioner
+ Steering
+ Suspension bracket
+ Wheels and tyres
+ Forward приводной a shaft shaft/bearing. An oil epiploon
+ Kardannye shaft
- Brake system
   + Brakes
   + Brake highway/hose the brake cylinder
   + Forward brakes
   - Lay and back brake
      + The general description
      - Diagnostics
         Check and adjustment
         Vehicle service
         Cable of a lay brake
         Brake drum
         Brake колодка
         The brake cylinder
         Back plate of a brake
   + Antiblocking brake system (ABS)
+ Engines
+ Fuel system
+ Ignition system
+ Start system
+ Release system
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. An immobilizer
+ Electric equipment







e8f2b5b1

The brake cylinder

Removal

 PERFORMANCE ORDER

  1. Execute item 1 - 6 procedures of removal Has undressed the Brake drum.
  2. Execute item 2 - 4 procedures of removal of Section Brake колодка.
  3. Release накидную a nut of a brake highway (or nuts) but only so that the liquid did not follow.
  1. Remove adjusting boats of the wheel cylinder. Disconnect a brake highway (or highways) from the wheel cylinder and establish a cap of a stopper of a safety valve of the wheel cylinder (1) in a highway not to allow a liquid to pour out.

Survey

Examine the wheel cylinder, whether there are no wear tracks, cracks, corrosion or damages.

Clear components of the wheel cylinder of a brake liquid.

Installation (for not soldered type)

 PERFORMANCE ORDER

  1. Remove a cap of a stopper of a safety valve from a brake highway and connect a highway (or highways) to the wheel cylinder (1) so that the liquid did not proceed.
  1. Tighten the wheel cylinder on a back plate of a brake (1) according to an inhaling twisting moment. An inhaling twisting moment: a bolt of the wheel cylinder (a): 13 Н•м (1.3 kg th, 9.5 pounds-foots).
  1. The inhaling twisting moment накидной nuts (2) (or nuts) a brake highway (3) which has been connected in item 1 above, should correspond to the specification. An inhaling twisting moment: накидная a nut of a brake highway (b) — 16 Н•м (1.6 kg th, 12.0 pounds-foots).
  2. Establish a cap of a stopper of the safety valve, removed from a highway, back on a cap of a stopper of a safety valve.
  3. Then address to item 1 - 6 procedures of installation of Section Brake колодка.

Necessarily pit air from brake system (the operation description — see Razdel Stravlivanie of air from brakes in the Head Brake system).