Suzuki Grand Vitara SQ416/SQ420/420WD

Since 1998 of release

Repair and car operation

Suzuka Grandee Vitara
+ The general information
+ Maintenance service and greasing
+ Heater, ventilation and the conditioner
+ Steering
+ Suspension bracket
+ Wheels and tyres
+ Forward приводной a shaft shaft/bearing. An oil epiploon
+ Kardannye shaft
+ Brake system
- Engines
   + Mechanical part of engine G16
   + Mechanical part of engine J20
   - Engine cooling
      + The general description
      + Diagnostics
      + Maintenance service
      - Vehicle routine maintenance
         Plums of a cooling liquid
         Hoses or water pipes of system of cooling
         The thermostat
         Belt of the cooling fan
         The cooling fan and муфта the fan
         The water pump
         The gauge of temperature of a cooling liquid of the engine (EATS)
      Necessary service materials
      Technical characteristics of the rotating moment of an inhaling
+ Fuel system
+ Ignition system
+ Start system
+ Release system
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. An immobilizer
+ Electric equipment


Hoses or water pipes of system of cooling


For engines G16 and J20


  1. Disconnect a negative cable (-) from the accumulator.
  2. Merge cooling system.
  3. Untwist screws on each pipe or ослабьте clips of hoses and pull the hose end to remove these pipes or hoses.
  4. Remove the case throttle заслонок and an inlet collector


For engines G16 and J20  


  1. Establish the removed parts as it should be the return to dismantle procedure, without forgetting about the following.
  2. Reliably fasten everyone tightening a bolt.
  1. At installation of a water exhaust pipe (1) to a cylinder head, put hermetic on a carving of a bolt of a pipe and then fasten it (only for engine J20). Hermetic "And": 99000-31110.
  1. Fill system of cooling with a corresponding cooling liquid, having addressed to the description in Sections the Cooling liquid and Washing and filling of system of cooling in this Chapter.
  2. Check up each part on a leaking.