Suzuki Grand Vitara SQ416/SQ420/420WD

Since 1998 of release

Repair and car operation

Suzuka Grandee Vitara
+ The general information
+ Maintenance service and greasing
+ Heater, ventilation and the conditioner
+ Steering
+ Suspension bracket
+ Wheels and tyres
+ Forward приводной a shaft shaft/bearing. An oil epiploon
+ Kardannye shaft
+ Brake system
- Engines
   + Mechanical part of engine G16
   + Mechanical part of engine J20
   - Engine cooling
      + The general description
      + Diagnostics
      + Maintenance service
      - Vehicle routine maintenance
         Plums of a cooling liquid
         Hoses or water pipes of system of cooling
         The thermostat
         Belt of the cooling fan
         The cooling fan and муфта the fan
         The water pump
         The gauge of temperature of a cooling liquid of the engine (EATS)
      Necessary service materials
      Technical characteristics of the rotating moment of an inhaling
+ Fuel system
+ Ignition system
+ Start system
+ Release system
+ Transmissions
+ Coupling
+ Transfer
+ Forward and back differentials
+ Windows, mirrors, locks and security measures. An immobilizer
+ Electric equipment


The cooling fan and муфта the fan



  1. Disconnect a negative cable (-) from the accumulator.
  1. Merge cooling system, having turned off a drain stopper (1) radiators.
  1. Disconnect an inlet hose of a radiator from a radiator.
  2. Turn off cooling fans/nuts муфты.
  1. Remove распорные bolts (1) tanks of liquid P/S from a radiator support (only for engines G16).
  1. Remove clips of a casing of a radiator.
  2. Then remove cooling fan/muftu and a radiator casing.


Check up hydrodynamic муфту about oil leak. If it is necessary, replace knot муфты the fan (2). Do not assort knot муфты.

1 — the cooling fan
2 — knot муфты the fan
3 — a bimetallic part


Establish the removed parts as it should be the return to dismantle procedure.


  1. Fill system of cooling with a corresponding cooling liquid, having addressed to Sections the Cooling liquid and Washing and filling of system of cooling in this Chapter.
  2. After installation check up each connection about a leaking.